modular hip implants, cobalt-alloy, implant failure, fracture
Biomaterials | Biomedical Engineering and Bioengineering | Engineering
Two modular hip implants with a cobalt-alloy head and a cobalt-alloy stem were retrieved after a fracture had occurred in the neck region of the femoral component, eighty-five and seventy months after implantation. Both implants failed less than one millimeter distal to the taper junction between the head and the stem (outside of the taper). The fracture surfaces of the implant were investigated with the use of scanning electron microscopy, to determine the nature of the failure process. The fractures occurred at the grain boundaries of the microstructure and appeared to be the result of three factors: porosity at the grain boundaries; intergranular corrosive attack, initiated both at the head-neck taper and at the free surface; and cyclic fatigue-loading of the stem. The corrosive attack of the free surface was initiated, in part, by the egression of surface grains and by the ingression of fluid into the intergranular regions. Sectioned surfaces showed extensive intergranular corrosive attack in the prosthetic neck localized in the region of the head-neck taper junction and penetrating deeply into the microstructure.
Gilbert JL, Jacobs, JJ, Buckley, CA, Bertin, KC, Zernich, M, "Intergranular Corrosion Fatigue Failure of Cobalt-Alloy Femoral Stems: A Failure Analysis of Two Implants", J Bone and Joint Surgery, 1994: 76-A(1); 110-115.
Creative Commons License
This work is licensed under a Creative Commons Attribution 3.0 License.